Cylinders

Cylinder Barrels and Liners

A barrel is worth measuring before it is worth replacing. Most of these cylinders have enough metal left in them for several rebores, and a bore that is worn but still round and unscored is a better starting point than a secondhand barrel of unknown history. What actually ends a barrel is a bore past the last oversize anyone makes a piston for, a cracked or corroded fin, or a stud thread pulled out of the casting.

Listed here are cylinder barrels and liners together with the hardware that holds them down: base gaskets, holding-down studs, nuts and washers.

Brands & Models
Brands & Models
Tags
Tags

Rebore, reline or replace?

The measurement comes first. If the bore is still inside the largest oversize a piston is made in, a rebore is the straightforward answer and the piston follows the finished size. If it is beyond that, an iron barrel can often be relined and taken back to standard, which has the side benefit of putting a fresh surface into a cylinder that may have been bored three or four times already. An alloy barrel with a pressed-in liner is a different job again, and pressing a liner is work for someone with the tooling to do it square. Whichever way it goes, leave the piston order until the machining is finished and you have a figure in your hand.

What this category covers

  • Barrels: iron and alloy cylinders for the engine families we stock
  • Liners: for relining a worn or oversized bore
  • Holding-down hardware: studs, nuts, washers and base gaskets
  • Nearby: pistons, rings and head gaskets each have their own category

Measured it and still unsure?

Send the engine number, what the bore reads now and anything stamped or cast into the barrel itself. We will tell you what fits and what the realistic options are.