Surflex Clutch Plates & Parts

Friction material is one of the few things on a classic motorcycle that is better now than it was when the machine was built, and Surflex is the name most of our clutch listings carry. The Italian plates go into BSA, Triumph, Norton and Panther clutches, and they are specified by the engine the stack belongs to rather than under any model of their own.

We keep Surflex plate sets beside the springs, pressure plate hardware and primary components the same job calls for, so a clutch can be ordered in one go.

Categories
Categories
Tags
Tags

Count the plates before you order

Clutch stacks differ in how many friction plates they take, and on a machine that has been apart before the count is rarely what the manual says. Plates get left out and steels get put in where friction plates should be, and nobody writes it down. Lay the old stack out on the bench, count it, and measure the thickness of a friction plate against the figure for your engine. A set that is one plate short will slip under load however new the material is.

What goes with a set

  • Friction plates: Surflex sets listed per engine family
  • Steel plates: plain plates, listed with the sets they run between
  • Springs and adjusters: pressure plate springs, nuts and screws
  • Cables: clutch cables and fittings for the same machine

Bonded, or material for your own plates?

Some of these listings are bonded plates ready to fit and others are friction material to go onto the carriers you already have. If a description leaves you unsure which you are looking at, ask before the primary case goes back on, because the two are not interchangeable.