Alternators

Alternator Stators, Rotors and Charging Parts

An alternator failure on a classic rarely announces itself. The battery goes down over a week of short runs, the lights dim at idle, and the rotor turns out to have lost its magnetism years ago while the stator was still passing current. Testing both before buying either saves ordering the half that was never the problem.

Here we list the charging side of the primary drive: stators, rotors, and the nuts, keys and spacers that hold them in place, for the machines that left the factory with an alternator rather than a dynamo. Six and twelve volt systems are both covered.

Brands & Models
Brands & Models
Tags
Tags

Which half has actually failed?

Start with the rotor. A rotor loses magnetism with age and heat, and it will read as perfectly sound on a continuity test while producing almost nothing. A stator usually fails where you can see it: cracked encapsulation, chafed leads where they pass out of the chaincase, or a winding gone open circuit. Measure the output at the battery with the engine running before ordering either one, and check which voltage the machine is on now, because a rebuild somewhere in its past may have changed that along with the regulator. The number of leads coming out of the stator is worth noting too, since the output was wired differently depending on what the bike had to run.

What this category covers

  • Stators: encapsulated windings with their mounting hardware
  • Rotors: with the key and retaining nut where those were supplied together
  • Fixings: studs, nuts, shims and spacers that set the air gap
  • Nearby: ignition and wiring parts have categories of their own

Not sure which to order?

Tell us the engine number, the voltage the bike runs on now and what the output reads at a fast idle. We would rather work from those three figures than from a model name.